Water without the border changing brown

  • 1 Replies


  • *
  • Jr. Member
  • **
  • Posts: 82
« on: October 19, 2019, 06:28:39 AM »
Hi, I've played a few courses that have water hazards where either the heavy rough or light rough runs all the way up to the water edge and sometimes even below the surface giving a really strong appearance.

When I try to do this I just get brown edges and sometimes the light rough border gets swallowed up and looks awful so I have to move it further away from the hazard.

Does anyone know the work around for this please?
TGC 19 Courses:

Mill Ride GC, Berkshire, UK (L)
Stoke Park Country Club (L)
St Enodoc GC, Cornwall, UK (L)
West Hill GC, Surrey, UK (L)


  • *
  • Hero Member
  • *****
  • Posts: 6327
    • http://www.twitter.com/yeltzy
« Reply #1 on: October 19, 2019, 07:00:33 AM »
You need to place another layer of water underneath or right down far below the layer which is there.2 things one on the overhead view it will not show as water and 2 save before you do anything because i have found on xbox don't always work right.only save when it looks right.In my view just looks alot better in game.PS not sure how it works or how it looks if you using LIDAR.
« Last Edit: October 19, 2019, 07:05:40 AM by Yeltzman »