PLEASE HELP- I cannot clear the rough from tee box to green

  • 2 Replies
  • 179 Views

DolflundGreen

  • *
  • Newbie
  • *
  • Posts: 3
« on: May 06, 2020, 12:39:09 PM »
I'm having a difficult time clearing the rough that is generated from placing the "hole" - I'm able to spine the green and fairways to make a very good looking hole but cannot get the long patch of rough connecting from the tee box to the green to go away.

This issues is stopping me from publishing a few courses so any help is much appreciated! Thank you everyone!

 

less than bread

  • *
  • Sr. Member
  • ****
  • Posts: 346
« Reply #1 on: May 06, 2020, 12:50:07 PM »
Go to the settings tab in the designer, rough settings, and turn width all the way down
TGC 2019 Courses:
The Green Inferno
Old Red's Sandstone Range
Scorched Horizon Golf Club
Mighty Oak Lodge & Ranch
Kathmandu Valley Golf Club

Yeltzman

  • *
  • Hero Member
  • *****
  • Posts: 6428
    • http://www.twitter.com/yeltzy
« Reply #2 on: May 06, 2020, 01:01:45 PM »
Answer above is correct if you have auto generated rough on,if not please do reply. pic below need to set width to zero on heavy and rough  really to have something decent



If that does remove the light and heavy rough,if you placed a spline down for a fairway just use second texture option and it gives you some light rough round the fairway.
« Last Edit: May 06, 2020, 01:06:37 PM by Yeltzman »

 

space-cash