Flat tool to a specific level

  • 1 Replies


  • *
  • GroupMember
  • Hero Member
  • *
  • Posts: 1281
« on: February 22, 2015, 12:10:07 PM »
Just a small change... When you use flattern tool it moves up and down I assume relative to the average height.  Would be good to be able to either set a height or lock it in.  Trying to level a large area is difficult unless you can do it with a single brush stroke

Be interested to hear if anyone else has thought about/would like this :)
Full Courses:
Sandy Foot Links (TGCTLive Olympic Entry)
Royal Brumby
Tye Dunes II
Tye Dunes
Marazion Golf Club
University Links (TGCT 2015 Open Championship)


  • *
  • Hero Member
  • *****
  • Posts: 642
« Reply #1 on: February 22, 2015, 04:09:05 PM »
I think I might have already suggested flatten to highest, middle, lowest or up or down by a number of feet/yards.
Intel core I73770k 3.5 GHZ
16 Gb Corsair vengeance DDR3 1600MHZ/PC12800
Asus mobo PB8277-V Lx
Nvidea GeForce GTX670 2GB
X box 360 wired controller
Windoes 7 home premium 64 bit

Courses :
Aphrodite Golf and Sailing Resort
Taiga Forest-Kaunis Course
Adelaide Hills West Golf Course
Strathmally GC