Fairway Paint Problem

  • 2 Replies


  • *
  • Newbie
  • *
  • Posts: 49
« on: September 30, 2017, 10:54:53 PM »
I have started a new build using the Highlands theme and I have run into a problem.  I built a castle on an island using wall sections (it was a lot of work) and I would hate to lose everything I have done.  Here is a picture of the build so far...

When I went to add the fairway on top of the rough, it would not show up.  I zoomed in and selected the fairway to change the texture, but it automatically switches to the rough edit menu.  I tried switching to another theme, but got the same results.  I opened up another course I am building, and did not have this problem, so it seems it is only affecting this particular build.  There was a new patch that came out, and I am not sure if it is related to that or not?  Is anybody else having this problem?
Edmeister.... but you can call me Ed


  • *
  • Hero Member
  • *****
  • Posts: 1644
« Reply #1 on: October 01, 2017, 01:55:48 AM »
Try the red raise sculpting brush , lift the land
while holding the x button down, you'll see the
land come up when you release the x button it
drops back down, and hopefully the fairway should
appear, you might have to repeat this a few time.

 hope this helps.. Icyken...

Club Sopranos
Isle of Bute              
Hermit of mink Hollow
Machrihan Dunes        
The Celtic isles          
Craigendoran Links  
Prestwick  Scotland    
Helensburgh  GC       
Ayrshire Gailes  
Rosemount  Scotland
St Nicholas  Prestwick


  • *
  • Hero Member
  • *****
  • Posts: 936
« Reply #2 on: October 01, 2017, 03:50:21 AM »
Use the RED brush to raise the landscape and the fairway should appear, any humps you may find you can use BLUE brush to flatten, Nigel