GNCD Stuck Deleting Items/Width 0

  • 2 Replies
  • 1250 Views

leeish

  • *
  • Jr. Member
  • **
  • Posts: 62
« on: October 19, 2014, 01:46:50 AM »
Ive had this happen several times and the only fix is to exit the GNCD and reenter. Its like the game gets stuck deleting or setting widths to 0. As I move the cursor over another surface it immediately goes to 0 width. When complete if I move the cursor, that surface goes to 0. If I move to a different hole, does the same and I have to exit.  Its rare but has happened a few times building the 4 courses I've made.

Sent from my Surface Pro 3 using Tapatalk

Cheagles

  • *
  • Guest
« Reply #1 on: October 20, 2014, 12:00:47 PM »
Hey Leeish, thanks for the report.  Just so I'm clear on this, when it happens, any surface that you scroll over is being set to 0 width?  Even if you choose a different option like sculpting or adding objects?

leeish

  • *
  • Jr. Member
  • **
  • Posts: 62
« Reply #2 on: October 21, 2014, 11:49:30 PM »
If I remember it happens no matter if I change my tool or not, but I can't be sure. Usually when it starts I just hit undo, undo to get back to where I was and exit so I'm not usually messing around long enough to test anything. If it happens again I'll play around and see if I can get any more info.

Sent from my Surface Pro 3 using Tapatalk

 

space-cash